Will the NGW-1 transmit data on its NMEA 0183 output that is received on the NMEA 0183 input?

Will the NGW-1 transmit data on its NMEA 0183 output that is received on the NMEA 0183 input?

This is unfortunately not possible.  Doing so would create a data loop which will quickly use up the narrow bandwidth available to NMEA 0183 devices and prevent vital data from being transmitted.

    • Related Articles

    • NMEA 0183 device not receiving data from NGW-1

      If your NMEA 0183 Listener is not showing any data when connected to the NMEA 0183 output of an NGW-1, the first step for fault finding should be to see if the NGW-1 supports the conversions you need. For more information on the steps taken when ...

    • Connecting multiple NMEA0183 Listeners to NGW-1

      NMEA 0183 Output It is perfectly acceptable to connect up to eight devices to the NGW-1 NMEA 0183 output provided that they are all individually electrically isolated, depending on the electrical demands from each device. However, please check with ...

    • Sharing NMEA 0183 Data with a PC

       Connecting NMEA 0183 devices directly to a PC without isolation is not recommended as this can cause ground loops which will damage your PC and your NMEA 0183 devices.  For examples of different connection methods, refer to the following article: ...

    • Converting Multiple NMEA 0183 Talkers to NMEA 2000

      Unfortunately it is not possible in any NMEA 0183 networking situation to connect the output of more than one Talker to the input of one or more Listener/s.  To convert data from more than one NMEA 0183 Talker to NMEA 2000 you have two choices which ...

    • Configuring the NGW-1 using Toolkit

      For a detailed explanation of using Toolkit to configure the NGW-1, please visit the following Article: https://www.actisense.com/knowledge-base/nmea-2000/ngw-1/configuring-the-ngw-1-using-toolkit/